How to make a passport photo with Photoshop

Here are the steps to create a passport photo using Photoshop:

Open Photoshop and create a new document with a width of 2 inches and a height of 2 inches.

Go to "File" > "Open" and select the photo you want to use for the passport photo.

Use the "Crop" tool to crop the photo to a square shape. The photo should be centered with your face taking up 70-80% of the frame.

Resize the photo to fit within the 2-inch by 2-inch document by going to "Image" > "Image Size". Change the units to inches and make sure the width and height are set to 2 inches.

Adjust the brightness and contrast of the photo to make it look clear and sharp. Go to "Image" > "Adjustments" > "Brightness/Contrast" and make the necessary adjustments.

Use the "Lasso" tool to select your head and shoulders, then go to "Select" > "Inverse" and press "Delete" to remove the background.

Save the image as a JPEG or PNG file, making sure the resolution is 300 dpi or higher.

Your passport photo is now ready to be printed or submitted electronically for your passport application.

How To make bootable pendrive using MS-DOS command

To Make A Bootable Pen Drive Using MS-DOS Command. 

To Create A Bootable Pen Drive You Can Follow These Steps:

Connect your pen drive to your computer's USB port.

Open the Command Prompt in Windows by typing "cmd" in the Run dialog box (Windows + R) or searching for it in the Start menu.

Type "diskpart" in the Command Prompt and press Enter. This will open the DiskPart tool.

Type "list disk" to display a list of all the disks connected to your computer.

Identify your pendrive by looking at the size of the disk. For example, if your pendrive is 16 GB, it will be listed as Disk 1, with 14 GB or so of unallocated space.

Type "select disk #" (replace # with the number of your pendrive) and press Enter.

Type "clean" and press Enter to erase any existing data on the pendrive.

Type "create partition primary" and press Enter to create a new primary partition on the pendrive.

Type "select partition 1" and press Enter to select the partition you just created.

Type "active" and press Enter to make the partition active.

Type "format fs=fat32 quick" and press Enter to format the partition with the FAT32 file system.

Type "assign" and press Enter to assign a drive letter to the pendrive.

Copy the boot files from the operating system or software you want to make the pendrive bootable for, to the root directory of the pendrive.

Type "exit" and press Enter to close the DiskPart tool.

Your pendrive is now bootable and ready to use. You can use it to install an operating system, run a diagnostic tool, or perform other bootable tasks.